Contact
Brian Carroll
Tried on single ply fusion deadlift suit. Fairly tight in the legs and had difficulty getting down low enough to get in proper position. Is this normal and is the inzer max deadlift suit any easier to get into position. I normally pull sumo but did try both stances to see which position would be easier. I’m 6′ 320 and very new to gear lifting just trying to make the best decision on gear selection as to not waste money
Allison gave some great advice! Getting to the bar is a task in the deadlift when wearing gear. I start with the bar just a little out infront of me, grab as much air as I can and then reach with the under hand first. I make sure I roll it deep into the palm then use the grip of the bar to reach with the over hand. Hope that helps! Stick with it, the pop from the straps is a big part of equipped lifting.
great answers: in short it should be hard. The harder to get down, the more pop off the floor (when done right). Not always simple
Allison does it well conventional and byrd does the same sumo, so this comes from both angles. Thanks